I ordered the DD-kit for my Eliminators.
They are great!
However, I ran into an issue on the slave pedal.

After installing the direct link, I noticed that the direct link was hitting the axle of the pedal while rotating. (even when I set the setting of the DD-kit in the lightest way)
Besides this, the slave pedal also felt a LOT heavier to play, compared to the main pedal.
I held both beaters back until the links hitted the axles, and I noticed that the main pedal goes further back.
I measured the distance from the direct link to the axle. The distance on the slave pedal was like 5mm shorter...!
I always assumed that both pedals have the same dimensions, cams and distances. But this seems not the case?
Both direct links were placed in the centered bolt hole. So it should be all the same, right?

Obviously the issue is not caused by the DD-kit 😉

Somehow the cam (and the axle) on the slave pedal sits a bit more the back, compared with the main pedal.
I discoverd this, because the Eliminators have a indicator for the beaterangle.
Both beaterangles are the same, but both angle indicators are not!

On the main pedal, the indicator-line sits between the middle (biggest) line and the smaller line on the right.
That means that the beater angle is a bit smaller than factorysetting.
On the slave pedal, the indicator-line sits exactly on the middle line (factorysetting) but both beaterangles are the same.
Something is not right here.
(hope this makes sense to you guys)

I switched the springs to check if they caused the problem, but the issue is the same.
I tried to place the beaterholder 1 step back on the hex-axle. But then the beater sits to far back...

What could be the cause of my problem...?
I hope someone can help me :-)

Elim1.jpg - Bild entfernt (keine Rechte)
Elim2.jpg - Bild entfernt (keine Rechte)
Elim3.jpg - Bild entfernt (keine Rechte)
Elim4.jpg - Bild entfernt (keine Rechte)
ACD3.jpg - Bild entfernt (keine Rechte)